Disassemble one bed frame and stow the parts. Measure the width and length of the remaining bed frame. Cut two of your beams to match the width of the bed frame. Cut the plywood sheet to match the width and length of the bed frame. Drill holes in one end of each post, placed on center and 12 inches from the end. Measure the height of the legs on the bottom bunk, from the bottom of the base to the floor. Then measure the same distance down the vertical post from the bottom of the top bunk base. Mark it on all four posts, then cut it. This cut will form the new legs of a single bed. To see if you can remove the bottom bunk piece only, use the correct tool for the bolts or screws on your model of the bunk bed. While some beds may allow you to remove the bottom bunk without taking the rest of the bed apart, you may have to disassemble the entire bed frame, including the top bunk. You can convert a bunk bed into a loft bed with ease. But one of the most important things you need to consider is the sturdiness and stability of the frame. Removing the bottom beam should not affect the stability of the bed in any way. You can also use reinforcement to make it sturdy if that be the case. Move that bunk bed outdoors after removing the mattresses, then repurpose some of the lower planking to create a full, solid floor and partial walls for the top. The former top bunk is the new play area, like an open-air tree fort, sans tree. Add a climbing rope and reuse the old bunk ladder as a means to climb up.
How to Separate Bunk Beds Consult the paperwork that came with your bunk bed to ensure that they can be separated safely. Remove the mattress from the top bunk. Remove the ladder. Unscrew and remove any bolts or slides holding the stacked beds in place. Lift the top bunk carefully off the bottom bunk at each corner.
However, data and reports consistently show that loft beds can be inherently dangerous for kids as well as young adults. The NCH reports that when children or teenagers experience bunk bed-related injuries that they are often more severe than any injury caused from standard beds.
How to Build a Loft Bed in an Afternoon (and on the Cheap) A loft bed with a high back shelf and side ladder. Use a scrap of wood to keep the legs in place. Drill the screw into your pilot hole. Repeat the pilot hole and screw process until you reach the end of each board. Carefully mark where your side support will go. C-clamps hold the supports in place while you drill.
10 Creative Ways to Decorate Under a Loft Bed Roll Out a Rug, Put a Beanbag and a Bookcase and a Cute Little Reading Nook Will be Made for Your Little Reader. Put Two Chairs and a Table for The Kids to Enjoy. If You Need Extra Beds for Kids' Sleepovers Then Utilize The Space Under Their Loft Bed. Create a Cozy Sitting Area by Placing a Couch.
Lift the top bunk, rotate the frame, and rest it atop the bottom bunk. Tip: Always lift the bunk from the side rails, do not lift the bunk from the mattress support slats. Find your bedpost extensions under your bed. Slot each extension into the lower bedposts, making sure the through-holes line up.